Westell/Versalink Gateway W Manual. products/pdf/ The Westell® VersaLink™ Gateway provides reliable. w) u • Read online or download PDF • Westell Technologies Versalink W User Manual. Westell W came out in and is still in use today as a simple and powerful DSL modem. Not only is the Westell W a wireless modem, it is also a wired.
|Published (Last):||24 November 2011|
|PDF File Size:||14.46 Mb|
|ePub File Size:||16.54 Mb|
|Price:||Free* [*Free Regsitration Required]|
The Network screen shows the settings for the newly created location. The following is a list of the possible responses: HOME As you navigate through the various screens of VersaLink, the name of the active page that you have selected ,anual appear in the upper-left corner of the screen, as shown below.
Otherwise, the 20 uses slot time is used. After you select the default profile, click the static NAT button.
Go to Configuration at the homepage menu and select Services. To enable Remote Access, type in a password and click the enable remote access button. Plug the Ethernet cable into your computer, for a wired connection. Comments to this Manuals Your Name.
Westell advises setting this to enabled for the private LAN. This is the station firmware that the card would use to operate as a wireless station. Beacons contain rate and capability information.
The System Self Test will run a diagnostic test that executes independent of firewall security settings. Hollan Johnson is a freelance writer and contributing editor for many online publications.
Westell Technologies 327W User Manual
The DNS Server was unable to find an address for the given host name. Page of Go. Type The type of NAT service configuration you selected. Plug the Westell W into a power source and plug the phone line into a phone jack nanual into the modem. If you clicked on OK, the following screen will be displayed. No device is displayed in the field adjacent to the static Nat button.
Success VersaLink has successfully obtained the resolved address. Try starting with and mnaual ports if needed server query, if master server uplink is enabled.
By pressing ‘print’ button you will print only current page.
If you select edit from the Service Configuration screen, the following screen will be displayed. The type of message displayed depends on the menu that you are viewing. If you click OK, you will allow incoming connections to be forwarded to a designated local PC.
The following screen will be manuaal If you click edit, the following screen will be displayed. Select Search for the best driver for your device. If you click on reset, this screen will refresh amnual display your last saved QoS configuration.
The updated firmware may be loaded from either a file that is located on your PCs hard drive or from update files stored on an Internet server. After you enter your data into the appropriate settings, click on change. Factory defaults become current configuration. Static NAT is now enabled for the device you selected. Programming Flash is a temporary storage area for uploaded files.
The Locate Driver Files window appears. VersaLink will be reset and the new configuration will take effect. The following pop-up screen will be displayed. Click If you click OK in the preceding pop-up screen, the following screen will be displayed. If you need to reset VersaLink to factory default settings, push the reset button on the rear of VersaLink.
Windows 98 SE Note: Remember, you may attach an unlimited number of NAT services to any profile. The Install Hardware Device Drivers window appears.
westell versalink w manual Questions & Answers (with Pictures) – Fixya
Windows 98 SE 2. You must be connected to the Internet to use this option. Indicates whether a static route should be advertised via RIP. The screens below show that the file upload has completed and that the Programming Flash is being erased to prepare the Flash storage area for upload of the new file.
If you click the set VC button, the following pop-up screen will be displayed. You may now browse the Internet. The password should be at least 4 characters long and should not exceed 32 characters.
It is not recommended that these settings be changed.