User Manual. Mic Preamp/Processor. Professional Audio Equipment. ® . Congratulations on choosing the dbx s Mic Preamp/Processor. The s is a . The dbx® s is a full featured Channel Strip Processor that delivers a studio quality Owner’s Manual-English [ MB]; Owner’s Manual-French [ KB]. English Owner’s Manual Downloads (Project 1) Owner’s Manual-English · (Project 1) Owner’s Manual-English · A (Project 1) Owner’s Manual-English.
|Published (Last):||9 August 2005|
|PDF File Size:||10.46 Mb|
|ePub File Size:||10.32 Mb|
|Price:||Free* [*Free Regsitration Required]|
Threshold – While talking or singing in the mic, bring up the threshold until the signal will no longer open the gate. You really need to experiment with these settings to get the best results.
Dbx A Owner’s Operation Manual (Page 31 of 68)
Comment by Qquincy on November 30, at 7: HighPass – Try pressing this button in. Enhancer LF Detail – Slowly turn up until the lows sound good, but not overbearing.
Five of these Dial adjustments are non-linear the scale is neither linear or logarithmic. Compressor Start with the density set to about 6 Drive – Turn up until you reach the desired amount of gain reduction.
Output Gain – Adjust this until you have the desired amount of level feeding the next device. Ratio – Adjust this setting until the background noise once again becomes audible, then turn it back up slightly until the noise drops in level.
If no De-Essing is required, turn it off. If the sound is too thin set it back out.
The Marketplace for Musicians |
This will properly set the Mic Input Gain without the added Gain effect of the the Compressor processing. If you want to set the gate, start by setting the ratio to Add a comment You need to be a member of Voiceover Universe to add comments! I just bought one and will be hooking it up over Christmas Now you should have your Gain Chain balanced.
Sign Dbbx or Sign In.
Notice anything wrong here! I hope this helps.
Sign in to chat! You may not be able to fully remove the noise, but you should be able to lower it.
Please update your browser to use Reverb
And the output gain to 0 dB. To set up the Gain Db, I proceed as follows: Density – Adjust until the release of the gain reduction suits your taste. Now back it off until the gate will open when the signal is present. Check the gate with the signal. Please check your browser settings or contact your system administrator.